Operation - Husqvarna 325iLK+TAB850 Manual Del Usuario

To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING: Use protective gloves.
WARNING: Always use the cutting
attachment guard that is recommended for
the cutting attachment. See
page 19 .
WARNING: An incorrectly attached cutting
attachment can result in injury or death.
Assembly of trimmer heads
WARNING: When you install the cutting
attachment it is very important that the
raised section on the drive disc/support
flange engages correctly in the centre hole
of the cutting attachment. If the cutting
attachment is install incorrectly it can result
in serious and/or fatal personal injury.
WARNING: Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard, or the J-handle is missing when using
metallic cutting attachment, is fitted this can
cause serious personal injury.
To attach the trimmer guard for a trimmer
head
1. Hang the trimmer guard (A) onto the two hooks on
the plate holder (M).
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To connect the battery to the product
WARNING: Only use Husqvarna original
batteries with the product.
1. Make sure that the battery is fully charged.
12
2. Bend the guard around the shaft and attach it with
3. Put the locking pin (C) in the groove on the bolt head
Accessories on
To attach a trimmer head
1. Put the drive disc (B) on the output shaft.
2. Turn the output shaft to align one of the holes in the
3. Put the locking pin (C) in the hole to lock the shaft.
4. Turn the trimmer head (A) counterclockwise to

Operation

2. Push the battery into the battery holder of the
the bolt (L) on the opposite side of the shaft.
and tighten the bolt fully.
M
A
drive disc with the related hole in the gear housing.
attach.
A
B
C
product. The battery locks into position when you
hear a click.
L
C
1385 - 002 - 04.12.2019