Charging The Shaver - Braun Syncro System 7570 Manual De Instrucciones

+35°C
+15°C
6
Your Braun Syncro is supplied with a
Braun Clean&Charge (please see separate
use instructions).
Important
Only use the power supply cord set provided.
A damaged cord must be replaced immediately.
Description
1 Foil protection cap
2 Shaver foil
3 Cutter block
4 Foil release button
5 Long hair trimmer
Technical specifications:
• Wattage via cord set: 7 W
• Power supply via cord set:
100-240 V 2/ 50 or 60 Hz (automatic adaptation)
• Shaver input voltage: 12-24 V

Charging the shaver

• First charging: Using the power supply cord set,
plug the shaver into an electrical outlet with the switch
on position «0» and charge it for at least 4 hours
(plug might get warm).
• Once the shaver is completely charged, shave without
the cord until fully discharged. Then recharge to full
capacity again (subsequent charges will take about
1 hour).
• A full charge will give up to 50 minutes of cordless
shaving time depending on your beard growth.
However, the maximum battery capacity will only be
reached after several charging/discharging cycles.
• Best environmental temperature range for charging
is 60 °F to 95 °F / 15 °C to 35 °C.
6 Switch
7 Display
8 Info key
9 Pilot light
10 Shaver socket