English; Charging The Shaver - Braun FlexIntegral 5312 Manual Del Usuario

English

+35°C
+15°C
8
Our products are designed to meet the highest
standards of quality, functionality and design. We
hope you entirely enjoy your new Braun shaver.
Caution
• Do not use the shaver near, or over, basins filled with
water (e. g. bath tubs, showers etc.).
• For safety reasons, periodically check the cord for
damage and replace it, if it is loose in the shaver
socket.
1 Description
1
Foil protection cap
2
Triple shaving frame
3
Duo cutter block
4
Pop-out long hair trimmer
5
Switch lock
6
On/off switch
7
Low-charge light (red) (models 5316/5315 only)
8
Charging light (green)
9
Shaver socket
j
Switch for locking the swivel head («head lock»)
and for activating the pop-out long hair trimmer
(«trimmer»)
k
Release button

2 Charging the shaver

• When charging the shaver for the first time, connect
it to the mains and charge it (switch position «off»)
for at least 4 hours / model 5312: 8 hours.
Then shave without the cord until the red low-charge
light lights up.
(Model 5314/5312: shave without the cord until the
shaver runs distinctly slower.)
• Subsequent charges will take approximately 1 hour
(5312: 8 hours).
• Wattage: 5 Watts
Voltage range during charging: 12–240 V2/
50 or 60 Hz
(automatic adaption)
Best environmental temperature range for charging:
15 °C to 35 °C