Start Up - Truper ESMA-7A3 Manual De Instrucciones

Assembly
Auxiliary handle assembly
• For a safer operation use the auxiliary handle. Fit it
into any of the three mounting orifices. Use the one
that makes your job easier.

Start Up

The angle grinder is a manual power tool used to grind and cut steel, pipes, iron angles, brick, tile, stone and / or ceramic
pieces; to remove burr on metal surfaces, to level and make smooth welding lines. If the tool accessory is changed it can be
used to remove oxide and to polish metal surfaces and other materials.
Switch On
• Turn on the tool sliding the switch lock forward. Slightly press the
switch trigger (A).
• To stop the tool, press and release the switch (B).
Handle Rotation
• The grinder handle can tur to be operated easily according
to the job to carry out. Press the button to turn the handle (C)
and turn it into the desired position until hearing a click.
How to correctly hold the tool
Always hold the tool with both hands. Hold the handle
with one hand and the other hand hold the auxiliary
handle. Be careful not to obstruct the ventilation slots.
• Grinding:
For better results hold the tool 15° to 30° regarding the
work piece. Move forwards to backwards applying light
pressure with a constant rhythm. This way the work piece
does not get too hot, will not discolor and there will not
be rough edges.
• Cutting:
Do not press, tilt or oscillate the tool. Work at a moderate
speed. The disc should always rotate counterclockwise
since there is a risk the tool shoots out uncontrolled.
To cut hard stones using a diamond cutting disc is
recommended.
C
A
B
C
ENGLISH
7