Manuales relacionados para Truper ESMA-4580N
Resumen de contenidos para Truper ESMA-4580N
- Página 1 Manual Angle 1.1 Hp ” grinder Power Wheel Applies for: Code Model 13870 ESMA-4580N ESMA-4580N Read this manual thoroughly CAUTION before using the tool.
- Página 2 Contents CAUTION Technical Data Power Requirements To gain the best performance of the tool, prolong the duty life, General power tool safety warnings make the Warranty valid if necessary, and to avoid hazards Safety warnings for angle grinders of fatal injuries please read and understand this Manual before Parts using the tool.
- Página 3 Technical Data ESMA-4580N Code 13870 Description Angle grinder Grinding wheel ” Voltage 127 V Frequency 60 Hz Current Power 1.1 Hp Speed Screwed thread size 11 000 RPM 5/8-11-UNC-1A Duty cycle 50 minutes work per 20 minutes idle. Maximum 6 hours per day.
- Página 4 General power tool safety warnings WARNING! Read carefully all safety warnings and instructions listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references.
- Página 5 Safety warnings for angle grinders This power tool is intended to function as a cutting tool. Read all safety warnings, instructions and specifications provided.Failure to follow the instructions outlined below may result in electric shock, fire and/or serious injury: While operating the grinder Select the right disc CAUTION •...
- Página 6 Safety warnings for angle grinders DANGER KICKBACK (Sharp Recoil) Do not use accessories that are not specifically designed and recommended by the manufacturer. The fact that the Kickback (sharp recoil) is a sudden reaction when a accessory may be installed on the power tool does not rotating wheel, backrest, brush, or other accessory gets stuck or snagged.
- Página 7 Parts Lock nut wrench Clamp (Included) lever Protective guard Handle Axis lock Switch ” grinding wheel included Axis Auxiliary lock handle Outer ” grinding wheel Protective flange ABT-386 included guard Switch Inner flange Auxiliary handle assembling orifice Clamp Power lever Vent Power cord supply cable...
- Página 8 Preparation Auxiliary handle assembly CAUTION Before performing any operation, always make sure that the auxiliary handle is firmly installed. Set the auxiliary handle in one of the three positions according to the operator's preference and the job to perform. Start Up The angle grinder is a manual power tool used to grind and cut steel, pipes, iron angles, brick, tile, stone and / or ceramic pieces;...
- Página 9 Maintenance • Always disconnect the tool before cleaning. • Never use water or other liquids. Use only a brush. • To prevent the motor to overheat clean the ventilation slots regularly. • Check all the tool components are perfectly fixed. •...
- Página 10 Notes ENGLISH...
- Página 11 Authorized Service Centers In the event of any problem contacting a Truper Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 018-7873 to get information about the nearest Service Center.
- Página 12 06060, where you can also purchase parts, components, consumables and accessories. The costs of transportation of the product that derive from its fulfillment of its service network are included. Truper® will not require any proof of purchase to make the warranty effective. Phone number 800-018-7873. Made in China.