2. Separate the water supply line from
the refrigerator
1. Remove one or two water lines, depending on
the model, by pressing each coupler ( 1 ) and
pulling the water lines ( 2 ) away.
CAUTION
Do not cut the water line.
Gently separate it from the coupler.
3. Remove the freezer door
A few things to mention first.
• Make sure that you lift the door straight up so
the hinges are not bent or broken.
• Be careful not to pinch the water tubing and
wire harness on the door.
• Place doors on a protected surface to prevent
scratching or damage.
• Is necessary, have two people disassemble the
doors.
DA68-02981J-07.indb 12
1. With the Freezer door closed, remove the
upper hinge cover ( 1 ) using a screwdriver,
and then disconnect the wires by gently pulling
them apart ( 2 ).
(1)
Be careful not to damage the sensor
(1)
harness with the hinge cover.
(2)
2. Disconnect the electrical harness.
3. Gently lift the clamp.
To prevent damage to the clamp or
injuries, do not lift the clamp forcefully.
4. Pull the clamp to remove.
Remove the ground screw by turning it counter-
clockwise.
English - 12
Pressing
(2)
2018. 7. 4.
1:59