Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SERVICE AND ADJUSTMENTS
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST MENTS:
• Depress brake pedal fully and set parking brake.
• Place attachment clutch in "DISENGAGED" position.
• Turn ignition key to "STOP" and remove key.
• Ensure the blades and all moving parts have completely stopped.
• Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
TO REMOVE MOWER (See Fig. 23)
•
Place attachment clutch in "DIS EN GAGED" position.
•
Lower attachment lift lever to its lowest position.
•
Remove mower belt from electric clutch pulley (M). See
Mower Drive Belt Removal in "TO REPLACE MOWER
BLADE DRIVE BELT" in this section.
CAUTION: After rear lift links are discon-
nected, the attachment lift lever will be
spring loaded. Have a tight grip on lift
lever when changing position of the lever.
•
Go to either side of mower and disconnect mower
suspension arm (A) from chassis and rear lift link (C)
from rear mower bracket (D) - remove retainer springs
and washers.
•
Go to other side of mower and disconnect the suspen-
sion arm and rear lift link.
•
Disconnect front link (E) from front mower bracket (H).
•
Slide mower out from under right side of tractor.
C
D
A
C
D
TO INSTALL MOWER (See Figs. 23 - 28)
Ensure tractor is on level surface and engage park ing brake.
•
Lower attachment lift lever to its lowest position.
CAUTION: Lift lever is spring loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position.
NOTE: Ensure mower side suspension arms (A) are point-
ing forward before sliding mower under tractor.
•
Slide mower under tractor until it is centered under
tractor.
•
ATTACH MOWER SIDE SUSPENSION ARMS (A) TO
CHASSIS - Position hole in arm over pin (B) on outside
of tractor chassis and secure with retainer spring.
•
Repeat on opposite side of tractor.
Fig. 23
20
M
E
H
B
Publicidad
Capítulos
Tabla de contenido
