Remote Control; Operating Tv, Cable Tv, Vcr And Cd Player - Aiwa AV-D77 Manual De Instrucciones

REMOTE CONTROL

OPERATING TV, CABLE TV, VCR
AND CD PLAYER
You can control basic functions of a TV, CABLE TV, VCR and CD
player with this remote control.
TO ENTER THE ID CODE OF THE
EXTERNAL EQUIPMENT
Before attempting to control them, be sure to enter the ID code
of the external equipment to the remote control as follows.
1 Confirm the code number of the external
equipment.
See the ID code list in the "APPENDIX" at the end of this
manual.
2 Press either the TV, CABLE, VCR or CD button in
the MODE SELECT area.
NOTE
When entering the ID code of a DSS satellite, press the
CABLE button.
3 Press and hold the SET UP button for about 3
seconds.
Confirm that the indicator blinks twice while pressing the SET
UP button.
4 Press four DIGIT buttons which correspond to
the ID code of the external equipment.
For example, if your CD player is an AIWA unit, the required
ID code is 0124 or 0157. In this case, press the DIGIT buttons
in the order of "0," "1," "2" and "4" (or "0," "1," "5" and "7" ).
After the fourth DIGIT button is pressed, the indicator blinks
twice indicating that the ID code is correct and is stored on
the remote control.
To confirm the stored ID code
You can check the stored ID code by counting the indicator blinking.
1 Press either the TV, CABLE, VCR or CD button.
For example, to check the stored code for CD player, press
CD.
2 Press and hold the SET UP button for about 3 seconds.
3 Press "9," "9" and "0."
4 Press "1," and count the indicator blinks.
For example, in the case that the stored ID is "0157."
The indicator does not blink.
5 Press "2," and count the indicator blinks.
The indicator blinks once.
6 Press "3," and count the indicator blinks.
The indicator blinks five times.
7 Press "4," and count the indicator blinks.
The indicator blinks seven times.
TO CONTROL TV, CABLE TV, VCR AND CD
PLAYER
1 Press any button in the MODE SELECT area (TV,
CABLE, VCR or CD).
The remote control is ready to operate the selected mode
equipment.
2 Press one of the buttons indicated above.
For the use of the 0 – 9 and the ENTER buttons, see the
instruction manual supplied with the unit to be controlled.
Other buttons indicated above have the same function which
you will find on the unit to be controlled.
NOTE
• Reenter the ID code of the external equipment after replacing
the batteries of the remote control.
• If there are plural ID codes for external equipment in the
"APPENDIX," try each number listed until you can control the
external equipment.
n En
20
ENGLISH