Pleasant Hearth OFG777TA Manual Del Usuario página 13

ASSEMBLY INSTRUCTIONS
9. Burner Assembly Installation
9-1. Line up holes in the burner assembly (B) with
corresponding holes in the table assembly.
Insert four M5X12 screws (EE) through holes.
Fasten them. The control knob should face the
front side of the unit, the same as the door.
Hardware Used
EE
Screw M5 X 12
FF
Phillips screwdriver
9-2. The assembled unit will look like the figure 9-2.
10-1. Screw the knob (O) on the table lid (A) with
M4 X 5 screw (AA). Pour glass rocks (one pack)
(P) above the burner and put the table lid above
the burner assembly. Do not cover ignition screen
with glass rocks.
Caution: Never place a table lid on the
fire pit when in use. Ensure the fire pit
has cooled before placing a table lid over
the fire pit.
Hardware Used
AA
Screw M4 X 5
FF
Phillips screwdriver
9-1
X 4
X 1
9-2
10-1
X 1
X 1
13
EE
O O
P
B
AA
A