Fan Assembly - Craftmade Ellington FARII13ABZ3RW Guia De Instalacion

5. Fan Assembly.

Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
Locate canopy cover in hardware pack. Loosen
yoke set screws and nuts in yoke at top of motor
assembly and remove pin and clip from yoke.
Slide downrod through canopy, canopy cover*
and yoke cover.
*NOTE: Canopy cover must be turned with shiny
side toward the motor assembly.
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the upper
end of the downrod.
Place downrod into the yoke in motor assembly
and re-insert pin and clip. Securely tighten yoke
set screws and nuts. Lower yoke cover to motor
assembly.
NOTE: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common
sense and caution are necessary factors in the
installation and operation of this fan.
With the hanging bracket secured to the outlet
box and able to support the fan, you are now
ready to hang your fan. Grab the fan firmly with
two hands. Slide downrod through opening in
hanging bracket and then turn hanging ball so
that the straight edges of the hanging ball align
with the sides of the hanging bracket. Pull down
firmly on the downrod until it sits securely inside
the hanging bracket.
IMPORTANT: Due to the size (width) of this fan, it
is advisable to seek the help of another person to
hold the stepladder in place and to then help lift
the fan up to you once you are set on the ladder.
Find a secure attachment point (wood ceiling joist
highly recommended) and secure safety cable. It
will be necessary to use a heavy duty wood screw,
washer and lock washer (not supplied) with the
safety cable loop. If necessary, adjust the loop at
the end of the safety cable. The loop at the end of
the safety cable should just fit over the threads on
the wood screw. Extra cable slack can be left in
ceiling area.
electrical wiring
downrod
canopy
yoke cover
clip
wood
ceiling
joist
canopy
page 4
safety cable
canopy cover
yoke set screw
and nut
pin
motor
assembly
safety cable loop
wood screw
and washer
safety cable
motor
assembly