Transformer And Dryer Plug-In; Filling Soap Tank And Priming The Soap Spout - Bradley Advocate AV Serie Manual De Installation

AV60
Soap/Faucet, Transformer and Dryer Plug-In
8
120V Installation: Plug the soap/faucet
transformer into the wall outlet at this location.
A
230V Installation: Affix the in-line soap/faucet
transformer on top of the left frame bracket.
Plug one of the two power cords from the wall
outlet to the inlet of the transformer.
B Place your hand beneath the faucet to activate.
Purge the air from the supply line. See step 10
for water temperature adjustment.
Plug the dryer motor power cord into the wall
C
outlet at this location (20 amp circuit required
for 120V installation. 10 amp minimum circuit
required for 230V installation).
D
Plug the other end of the dryer motor power cord
into the dryer motor assembly (see page 14).
E
Turn the dryer on/off switch to the
ON position.
Filling the Soap Tank and Priming the Soap Spout
9
(Model AV-Series Soap-1)
Place the soap key into the keyhole
on the soap body base. Push the
A
soap key up and gently rotate back
until soap cover unlatches from the
soap body base. Rotate the soap
cover up.
Soap level indicator light; blinks
red when soap level is low.
To ensure optimal soap
dispenser performance,
wipe down soap nozzle
with warm water. This
will help prevent the
buildup of soap.
18
#10-24
Flat Head
Security
Screw
(optional)
Contact
Bradley
Activate the soap spout by placing your
hand beneath the soap nozzle for 15
seconds. Keep your hand in place once the
C
soap starts to activate for up to 30 seconds.
After 8 to 12 activations, the pump has been
primed and your hand can be removed
from under the nozzle. The LED light will be
blinking green during the Auto Prime mode.
1/21/2014
120V installation shown.
After the soap system is primed, pour
soap into the soap fill hole to fill the (64-
D
ounce capacity) soap tank. An audible
"chirp" will sound and increase in intensity
when the tank is approaching 95% full.
E
Rotate the spout cover down and
clip the cover into the spout body.
Pour 6-8 ounces of water
B
into the soap fill hole to
prime pump.
Bradley • 215-1772 Rev. D; ECN 13-08-028
Installation