Denon DJ X1850 Prime Guia Del Usuario página 15

•
FX List Customize: Use this screen to customize the order of effects. Turn the FX Select/Enter knob
to select an effect from the list of available ones on the left side, and then press the knob to add the
effect to the new order on the right side. Repeat this step for each effect, or select -Cancel- to return to
the previous screen. After you have done this for all effects, select -End- to save your customized list.
•
BPM FX On Color: This setting determines the color of the BPM FX On/Off button while it flashes:
red, spring green, green, light blue, blue, yellow, orange, or purple.
•
Noise Level: This setting determines the level of noise when using the Noise Sweep FX: -20dB to
+15dB.
•
FX Quantize: This setting determines the amount of time FX will wait before turning on after the BPM
FX button is activated: 1, 1/2, 1/4, or 1/8 beat. This will keep the FX in time with the beat grid of
connected media players.
•
FX Limiter: Turn this setting On to limit the volume of the FX output so it is equal to the input from the
channel. Select Off to apply no limiter to the FX.
Advanced Audio
These settings determine the mixer's digital operation and other advanced functions.
•
Sampling Rate: This is the sampling rate of the USB audio signal: 44.1kHz, 48kHz, or 96kHz.
•
Master Out Level: This is an offset to the volume level of the master outputs: -15dB to 0dB.
•
Master Limiter: This applies a limiter to the master output: 20dB to 0dB. Select Off to apply no limiter
to the master output.
•
Booth Settings: These settings determine the routing for booth audio:
Booth Pan: This setting determines whether the booth audio can be panned along with the
o
master audio (Enable) or not (Disable).
Booth Out Level: This is an offset to the volume level of the booth: 0dB to -15dB.
o
•
USB Audio: These settings determine the routing and levels of USB audio.
CH1–4/Master/Cue Assign: These settings determine which USB audio channels (1/2–9/10) will
o
receive the audio signal from Channels 1–4 (CH1–CH4), and the master mix (Master).
Output Level: This is an offset to the volume level of the master mix sent to your computer over
o
a USB connection: -20dB to +20dB.
Ch Input Level: This is an offset to the volume level of the audio signals sent to Channels 1–4
o
from your computer over a USB connection: -20dB to +20dB.
•
DVS Setup: For Channels 1–4 (CH1–CH4), select the input level each one will use when its input
selector is set to DVS. Select Phono to use control vinyl records or Line to use control CDs.
•
Digital Settings:
Digital Out: This is an offset to the volume level of the audio signal sent from the digital out:
o
-20dB to +20dB.
Digital Link: Select On to sum the outgoing signal before the Master knob and Booth knob,
o
which you can use to control their output level. Select Off to sum the outgoing signal after the
Master knob and Booth knob, which will have no effect on the output level.
Link Level: This is an offset to the volume level of the audio signal sent to the Digital Link In:
o
-20dB to +20dB.
•
Cross Fader Cut: These settings determine how far you must move the crossfader from each side
(Fader Cut A or B) for it to start affecting the audio signal: -2.0mm to 1.0mm
15