Denon DJ X1850 Prime Guia Del Usuario página 16

System
These settings determine overall operation.
•
Info: These screens contain information about the current firmware version and network information.
Version: This is the current X1850 PRIME firmware version.
o
IP Address: This is the IP address that X1850 PRIME is using.
o
MAC Address: This is the MAC address that X1850 PRIME is using.
o
Hardware: This is the current hardware version.
o
•
Display:
Display Brightness: This setting changes the brightness of the OLED display: Low, Med, or
o
High.
LED Brightness: This setting changes the brightness of all LEDs on the control surface: Low,
o
Med, or High.
•
Engine Connect: Select Auto to enable X1850 PRIME to automatically receive timing and BPM
information (to synchronize effect tempos) from compatible media players connected to its Link ports
and to send track and user profile data between them. X1850 PRIME will also automatically detect
and configure each media player once you connect their Link ports. Select Manual to disable
automatic linking and only activate this feature manually by pressing and holding the Engine Connect
button until the Channel Assignment screen appears on the media players. You can then freely assign
each media player layer to a specific channel.
•
Cue Settings:
Cue Solo Mode: Select On to use the Channel Cue buttons as "solo" buttons (pressing one will
o
mute all other channels). Select Off to use them as normal cue buttons (pressing one will send
its signal to the cue channel).
Inactive Cue State: This setting determines the off state of the Cue LEDs: DIM or Off.
o
Cue 1–4 Color: This setting determines the color of the Cue buttons for each channel: red,
o
spring green, green, light blue, blue, yellow, orange, or purple.
Reset Cue Defaults: Select OK to return the Cue settings to their default values, or select
o
Cancel to return to the previous menu.
•
Contour Lock: When set to On, this setting locks the Crossfader Contour to the current knob position
so it is not changed if the knob is moved. Set to Off to disable the lock.
•
Through Position Lock: When set to On, this setting locks the Crossfader Assign switches to the
Thru position so it is not changed if the switch is moved. Set to Off to disable the lock.
•
Network Settings:
Refresh IP Address: Select OK to renew your IP address, which reestablishes the connection
o
between your X1850 PRIME and any compatible Denon DJ media players connected to the Link
ports. Select Cancel to return to the previous screen.
•
MIDI: These are MIDI settings that determine how the MIDI connections are used.
Clock Send: These settings determine whether or not X1850 PRIME will send MIDI Clock
o
messages over each of these connections. For each option, select On to enable transmission or
Off to disable it.

USB: This applies to both USB Ports 1 and 2. If you are using X1850 PRIME to control
software, set this to On.

5pin: This applies to the MIDI out.
Active Send: These settings determine whether or not X1850 PRIME will send normal MIDI
o
messages over each of these connections. For each option, select On to enable transmission or
Off to disable it.

USB: This applies to both USB Ports 1 and 2. If you are using X1850 PRIME to control
software, set this to On.

5pin: This applies to the MIDI out.
•
Factory Reset: Select OK to restore X1850 PRIME to its factory default settings (wait a few seconds
after selecting this before resuming normal operation). Select Cancel to return to the previous screen.
16