Bradley SN2003/IR Manual Del Usaurio página 2

SN2003/IR, SN2023/IR
Installation
Packing List
•
•
•
T H IS
•
E
S ID
U P
Supplies required for installation:
• 3/8" diameter bolts and floor/wall anchors to anchor washfountain pedestal to floor and wall
• 1/2" nominal copper tubing for hot and cold supply lines
• Standard P-trap (trap included with "B" or "H" drain type and some optional equipment)
• 1-1/2" drain lines and fittings
• Pipe sealant
Supplies recommended for installation:
• 1-1/2" vent or tie pipe on types vented through washfountain column
• Caulk (may be applied between backsplash and bowl to avoid debris accumulation)
• Electrical cut-off switch to the unit . This feature prevents accidental water delivery during regular
maintenance and service .
2
IMPORTANT!
Read this entire installation manual to ensure proper installation.
When finished with the installation, file this manual with the owner or
maintenance department. Compliance and conformity to local codes and
ordinances is the responsibility of the installer.
Separate parts from packaging and make sure all parts are accounted
for before discarding packaging material. If any parts are missing, do not
begin installation until you obtain the missing parts.
Make sure that all water supply lines have been flushed and then
completely turned off before beginning installation. Debris in supply lines
can cause valves to malfunction.
Product warranties may be found under "Products" on our web site at
bradleycorp.com.
9/5/2014
Bradley • 215-1073 Rev. L; ECN 14-00-007
Installation