Serial Ata Connectors; Additional Usb 2.0 Port Headers - Abit AN52S Manual De Usuario

1.8.2 Serial ATA Connectors

Each SATA connector serves as one single channel to connect one SATA device by SATA cable.
To connect SATA device:
1. Attach either end of the signal cable
to the SATA connector on
motherboard. Attach the other end to
the SATA device.
2. Attach the SATA power cable to the
SATA device and connect the other
end from the power supply.
The motherboard in this photo is served for DEMO only, and may not be the
※
same type or model as the one described in this user's manual.

1.8.3 Additional USB 2.0 Port Headers

Each header supports 2x additional USB 2.0 ports by connecting bracket or cable to the rear I/O
panel or the front-mounted USB ports of your chassis.
Make sure the connecting cable bears the same pin assignment.
※
1-14
Pin Pin Assignment
1 VCC
3 Data0 -
5 Data0 +
7 Ground
Pin Pin Assignment
2 VCC
4 Data1 -
6 Data1 +
8 Ground
10 NC
AN52S/AN52