Power Management Setup - Abit IX38 QuadGT Manual De Usuario

Network Controller
This option enables or disables the LAN controller.
- Invoke Boot Agent
This item allows you to use the boot ROM (instead of a disk drive) to boot up the system and
access the local area network directly.
Storage Controller
This option enables or disables the JMB363 controller that controls both IDE1 and eSATA1
ports.
- Controller Mode
This item selects the mode for devices connected through eSATA1 ports.
[RAID]: The on-chip Serial ATA served as RAID mode.
[IDE]: The on-chip Serial ATA served as IDE mode.
[AHCI]: The on-chip Serial ATA served as AHCI (Advanced Host Controller Interface) mode for
advanced performance and usability.

2.6 Power Management Setup

ACPI Suspend Type
- Resume by USB from S3
Power Button Function
Wake Up by WAKE# of PCIe
Wake Up by PME# of PCI
Wake Up by Onboard LAN
Wake Up by Alarm
x - Date(of month) Alarm
x - Time(hh:mm:ss) Alarm
Power On by PS2 KB/MS
x - KB Power ON Password
x - Hot Key Power ON
Restore On AC Power Loss
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values
ACPI Suspend Type
This item selects the type of Suspend mode.
- Resume by USB from S3
When set to [Enabled], this item allows you to use a USB device to wake up a system that is in
the S3 (STR - Suspend To RAM) state. This item can be configured only if the item "ACPI
Suspend Type" is set to [S3(STR)].
IX38 QuadGT
Phoenix – AwardBIOS CMOS Setup Utility
Power Management Setup
S3(Suspend-To-RAM)
Enabled
Instant-Off
Disabled
Disabled
Disabled
Disabled
0
0 : 0 : 0
Disabled
Enter
Ctrl-F1
Power Off
F6: Fail-Safe Defaults
Item Help
F7: Optimized Defaults
2-19