Stereo Return Section - Samson MIXPAD MXP144 El Manual Del Propietario

Top Panel Controls
20. BAL Control - This control is used to place, or position,
the stereo signal into the main left and right stereo mix
field. You can create a stereo image by panning some
input signals to the left and others to the right.
21. PEAK Indicator - This LED indicator will flash RED when
the channel input signal peaks. To reduce distortion,
turn the LEVEL control counterclockwise or lower the
volume of the input device until the clip indicator does
not light during normal use.
22. MUTE Switch - The MUTE switch allows you to turn the
channel on or off.
23. Volume Fader - The Volume Fader control adjusts the
level of each stereo input channel.

Stereo Return Section

The following section describes the features control of the
Stereo Return section.
24. Stereo ¼" Input Jacks - These ¼" jacks are for
connecting stereo line level sources like those from the
outputs of effects processors. The LINE inputs have a
nominal operating level of -40dBV through - 10dBV.
TRS phone jacks Connector pin-out - Sleeve: Ground,
Tip: Hot (+), Ring: Cold (-)
25. MON Master Send - The MON signals from mono and
stereo input channels, along with the Digital Effects
return, are mixed together and sent to the MON Output.
Use the MON level control to set the amount of signal
being sent to MON SEND jack.
26. FX Master Send - The FX signals from mono and stereo
input channels, are mixed together and sent to the
internal Digital Effects and the FX Output. Use the FX
level control to set the amount of signal being sent to
the internal Digital Effects and the FX SEND jack.
27. Volume Fader - The Volume Fader control adjusts the
level of Stereo Return.
14
18
19
20
24
21
22
24
23
25
24
26
25
26
27
27
25
26