Braun Activator 8595 Manual De Instrucciones página 10

new
10
Quick cleaning
Press the foil release buttons (12) to lift the shaver foil
(do not remove the foil completely). Switch on the shaver
for approx. 5–10 seconds so that the shaved stubbles can
fall out.
Thorough manual cleaning
Manual cleaning is recommended only when the
Clean&Renew™ station is not available, e.g. when travel-
ling. Never use water to clean the shaver.
Remove the shaver foil and tap it out on a flat surface.
Using the brush, clean the cutter block and the inner area
of the pivoting head. If you do not use the Clean&Renew™
station for a longer period of time, you should apply a drop
of light machine oil onto the shaver foil.
Replacing the cartridge
After having pressed the lift button (4) to open the
housing, wait for a few seconds before removing the used
cartridge.
Before discarding the used cartridge, make sure to close
the openings using the lid of the new cartridge, since
the used cartridge will contain contaminated cleaning
solution.
old
Cleaning shaver and Clean&Renew™ housing
Clean the housing of shaver and Clean&Renew™ station
from time to time using a damp cloth, paying special
attention to the opening of the station where the shaver
rests.
Shaver display
1. Pilot light: the shaver is connected to an electrical
2. Shaver is charging / Remaining charging time.
3. Self testing / Shaver is fully charged (a full charge
outlet.
will give up to 50 minutes of cordless shaving time,
depending on your beard growth).