Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Monitor and Camera Description:
2
1. LCD monitor
2. Power indicator
3. Loudspeaker
4. Microphone
5. ON/OFF button
6. TALK button
Installation:
Before installing the door viewer camera it is recommended to first check the correct operation of the
door viewer camera. Insert 3x AAA batteries in the battery compartment and connect the camera to
the monitor. Push the ON/OFF button and the monitor must show the picture of the camera. Check the
intercom function (TALK button) and the zoom function.
1. Check the height for the installation of the camera carefully before drilling a hole in the door. The
recommended height is between 1.60 m and 1.75 m. (door thickness, between 35 mm and 55 mm)
2. Drill a hole of ± 15 mm through the door.
3. Take off the cover sheet of adhesive tape.
4. Insert the tube with the flat cable through the opening in the door.
5. Push the camera unit against the door so that the camera unit is attached to the door with the
adhesive tape. Be sure there is enough space around the tube for the nut to tighten the camera
and the back plate.
6. Pull off the covers of the round adhesive tapes at the back side of the back plate and position the
back plate to the door with the opening in the middle of the hole from the door. Be sure that the
connector on the back plate for the flat cable is on the left side (see image).
1
3
4
5
6
7. Zoom IN/OUT button
8. Battery compartment
9. Camera lens
10. Microphone
11. Loudspeaker
12. Power indicator
3
9
10
7
8
11
12
Publicidad
Tabla de contenido
