CARLO GAVAZZI EM330 Instrucciones De Instalacion Y Uso página 8

Page
Total imported active energy**
l
I
Total apparent power
l
Total imported active energy**
l
Requested average power (d = demand) calculated for the set interval. The value remains the
l
J
same for the entire interval. It is = 0 during the first start up interval.
Maximum requested power (Pd = Peak demand) reached since last reset
l
Total imported active energy**
l
K Current tariff (t1 = tariff 1, t2 = tariff 2). Displayed if tariff management is on (Tariff = on).
l
Active energy imported with the current tariff. Displayed if tariff management is on (Tariff = on).
l
NOTE **: if easy connection is on (Measure = A), it indicates total reactive energy without considering the
direction.
NOTE ***: displays whether imported and exported energy are measured separately (Measure = b).
Single phase measurement pages
NOTE: the phase measurement pages and indicated information for each depend on the type of system
analyzed.
Page
Imported active energy. If easy connection is on (Measure = A), it indicates total energy without
L
considering the direction.
M Apparent power
Imported reactive energy
N
Power factor (L = inductive, C = capacitive)
O
P Phase voltage
Mains voltage
Q
Current
R
S Active power
Measurement faults
If the measured signal exceeds the admitted analyzer limits, a specific message appears:
EEE blinking: the measured value is out of limits
l
EEE on: the measurement depends on a value that is out of limits
l
NOTE: active and reactive energy measurements are displayed but do not change.
8021422 | EM330
Description
Description
©2014 | CARLO GAVAZZI Controls SpA| 8
Code
08
09
10
11
Code
12
13
14
15
16
17
18
19