Timer (Can Be Set Individually For Out1 And Out2) - CARLO GAVAZZI CA18EA Manual De Instrucciones

"Gated SR-FF" function
The function is designed (to: e.g. function) as a filling or emptying function using only two intercon-
nected sensors
Symbol
X – no changes to the output.
4
Sensor front
S.P., Two P.
1. SSC1 Window,
Adj. Hyst.
S.P., Two P.
2. SSC2 Window,
Adj. Hyst.
3. Dust 1
4. Dust 2
5. Temp
6. EXT-Input

2.4.4. Timer (Can be set individually for Out1 and Out2)

The Timer allows the user to introduce different timer functions by editing the 3 timer parameters:
• Timer mode
• Timer scale
• Timer value
2.4.4.1. Timer mode
This selects which type of timer function is introduced on the Switching Output. Any one of the
following is possible:
2.4.4.1.1. Disabled
This option disables the timer function no matter how the timer scale and timer delay is set up.
2.4.4.1.2. Turn On delay (T-on)
The activation of the switching output is generated after the actual sensor actuation as shown in
the figure below.
Selector Logic
A
A A - B
B
One of AND, OR,
1 to 6 XOR, S-R
divider
Selector Logic
B A - B
One of AND, OR,
A
1 to 6 XOR, S-R
B
divider
Rev.00 - 02.2020 | CA18EA/CA30EA Capacitve sensors with IO-Link interface | © 2020 | CARLO GAVAZZI Industri
Truth table
A B
0 0
0 1
1 0
1 1
Time Output
delay inverter
Out 1
ON, OFF N.O., N.C.
One-shot
Time Output
delay inverter
Out 2
ON, OFF N.O., N.C.
One-shot
Q
0
X
X
1
Sensor
output
Out 1
NPN, PNP,
Push-Pull
Sensor
output
Out 2
NPN, PNP,
EXT-
Push-Pull
Input
EXT-Input
13