Tv Screen Display Mode; Sleep Timer - Emerson CR202EM8 Manual Del Usaurio

W
ATCHING TV

TV Screen Display Mode

DTV
2 types of display modes can be selected in the digital mode when the
broadcasting station is sending 16:9 video signal.
1
Press [MENU] to display the main menu.
MENU
2
Use [CH K / L] to select "DTV SETUP", then press
[VOL X].
CH
or
CH
VOL
3
Use [CH K / L] to select "DTV DISPLAY", then use
[VOL X / Y] to switch the desired TV aspect ratio.
CH
or
CH
or
VOL VOL
LETTERBOX
[LETTERBOX]
Display the digital-supported program in full-screen.
Black borders will spread in the upper and lower
screen.
[ZOOM]
Enlarge and display the center area of the digital-
supported program.
The right and left side of image will be cut off.
4
Press [MENU] to exit.
MENU
Note:
• You may not switch the display mode depending on the
program.
14
EN
e.g.) digital TV mode
- TV SETUP -
PICTURE
CHANNEL SETUP
V-CHIP SETUP
LANGUAGE [ENGLISH]
CAPTION [OFF]
DTV SETUP
- DTV SETUP -
DTV DISPLAY [LETTERBOX]
DTVCC
ZOOM

Sleep Timer

The sleep timer can be set to automatically turn off the unit after an
incremental period of time.
1
Press [SLEEP] to set the sleep timer.
SLEEP
• Sleep timer display appears on the TV screen.
2
Press [SLEEP] repeatedly to change the amount of
time until shut off.
SLEEP
• You can set the unit to turn off after a set period of
time (from 30 to 120 minutes).
• Each press of [SLEEP] will increase the time by 30
minutes.
• After set up, the sleep timer display can be called up
for checking by pressing [SLEEP].
To Cancel the Sleep Timer
Press [SLEEP] repeatedly until "SLEEP OFF" is displayed
on the TV screen.
Note:
• The sleep timer setting display will automatically disappear
in a few seconds.
• When you disconnect the unit from the AC outlet or when a
power failure occurs, the sleep timer setting will be canceled.
SLEEP OFF
SLEEP 120 MIN.