Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
QUICK CONFIGURATION GUIDE. DT-202
3
NAVIGATION AND EDITION OF VALUES
Control Unit
3.1
The DT-800 control unit configures the DT-202 module:
1.-
After assembling and connecting, turn on the DT-800. After
scanning, check the DT-202 module appears in the list of
modules shown on the screen.
2.-
Press ENTER
access password (password by default "2008"). If the password is
right you will access to the configuration menu.
3.-
Use RIGHT
finding the DT-202. The LED "Program" of the DT-202 module
should be flickering when the module appears on screen.
4.-
Press ENTER
DT-202.
For more information, refer to the manual supplied with the DT-800
unit control.
Navigation through the configuration menu
3.2
•
Press the LEFT
options.
•
To exit a menu option, press the ENTER
•
To validate a change and exit, press the ENTER
•
To exit without validating press the ESCAPE
Editing a numeric field
3.3
1.-
Press the ENTER
11/2011
to get into the Password option and enter the
or LEFT
to move among modules, until
to get into the configuration option of the
or RIGHT
key to get into an menu option.
key to move among the menu
or DOWN
key.
key.
key.
Page 7
Publicidad
Tabla de contenido
