Greencut PP650X Manual De Instrucciones página 58

58
SWORD ADJUSTMENT
ATTENTION: The cutting blades are very sharp. Do not handle the cutter assembly unless the
protective cover of the blade is in place.
ATTENTION: Make sure that the "cutter bar" is locked in the storage/transport position (folded
back) and the protective cover is installed over the cutting blades when not in use.
1. Grasp the handle behind the hand guard with your right hand, and with your left hand, grasp the adjustment
lever of the blade assembly.
2. With the index finger of your left hand, press the release latch. With your left thumb, press the locking latch.
3. The cutting blade can be adjusted in various positions.
4. Remove the cover from the cutting blade. Now you can start the engine.
CHAIN ADJUSTMENT
ATTENTION: Always wear protective, cut-proof gloves when touching the cutting chain.
ATTENTION: Always disconnect the "spark plug wire" before touching the cutting chain.
ATTENTION: After using a new chain for 5 minutes, you should recheck the tension. An old chain
should be checked every 15 minutes of use.
1. Disconnect the "spark plug wire" before adjusting the chain.
2. Slightly loosen the 10 mm "main nut" on the "plastic cover" and tighten the chain tensioner with a flat
blade screwdriver until the chain is sufficiently tight to prevent it from jumping off the "guide bar", the chain
must have some looseness or the machine will be over-tightened.
TENSIONING THE CUTTING CHAIN
Wearing a pair of cut-proof protective gloves, pull the chain around the bar by hand and loosen the adjustment if
you feel tight spots.
PERFORM A RAPID TEST
A quick way to measure the tension of a chainsaw chain is to perform what is known as a "quick test". A properly
tensioned chain will quickly snap into place around the top of the bar and show no signs of sagging along the bottom
of the bar.
1. Start by disconnecting the spark plug wire from the chainsaw.
2. While holding the chainsaw in one hand, grip the chain along the top center of the saw bar with two fingers
of the other hand (Always wear protective cut-proof gloves and goggles when performing this test.)