JB Systems SUPER QUADRA BEAM Manual De Instrucciones página 9

ENGLISH
Fixture Hours
Used to show the number of working hours of the unit.
 Press the MENU button until
 Press the ENTER button to show the number of working hours in the display.
 Press the MENU button for about 2 seconds to return to running mode.
Software version:
Used to show the software version of the unit.
 Press the MENU button until
 Press the ENTER button to show the software version of the unit.
 Press the MENU button for about 2 seconds to return to running mode.
OPERATING INSTRUCTIONS
A. Standalone 1unit:
 Just connect the projector to the mains.
 Select one of the automatic show modes
 Don't forget to set the Blackout mode to 'NO Blackout' or nothing will happen.
 Refer to chapter HOW TO SETUP to learn how to make the previous settings.
Remark: You can connect a CA-8 remote controller to the unit if you want to have more control.
B. Two or more units in master/slave setup:
 Connect 2 or more units together. Refer to the chapter "electrical installation" to learn how to do this.
 Set the master mode for the first unit and select one of the shows.
 Set the slave mode for all the other units: each slave projector can be set to its specific slave mode
(see chapter HOW TO SETUP the slave mode)
 Connect all units to the mains and put on some music. The units will start working automatically to the
rhythm of the music and show the internal programs.
 Don't forget to set the Blackout mode to 'NO Blackout' or nothing will happen.
Remark: You can connect a CA-8 remote controller to the master unit if you want to have more control
over the master/slave operation.
C. Connect the optional CA-8 controller for more control:
The CA-8 controller can only be used in standalone or master/slave mode. Connect the controller to the
CA-8 input of the first unit (master). Now you can control all the connected units:
BUTTON
STANDBY
1.Synchronous strobe
2.Sound strobe in white
3.Sound strobe in color
FUNCTION
Strobe
MODE
(LED OFF)
D. Controlled by universal DMX-controller:
 Connect all the units together. Refer to the chapter "Electrical installation for two or more units in DMX-
mode". To learn how to do this (don't forget to address all the units properly!)
 Connect all the units to the mains and turn on the DMX controller.
Since each unit has its own DMX-address, you can control them individually. Remember that each unit
uses 1 or 3 DMX-channels as shown in the DMX charts below:
JB SYSTEMS
®
is shown on the display.
is shown on the display.
ACTIONS
To blackout all the fixtures
Select one of the different show modes.
Show
(LED ON)
7/47
OPERATION MANUAL
SUPER QUADRA BEAM