Publicidad
32 TO 70" TV STAND
M4X20
M6X20
M8X20
A (4 pieces
B (4 pieces)
C (4 pieces)
M10X50
M6X16
M4x12
E (4 pieces)
F (8 pieces)
G (4 pieces)
INSTALLATION
1a
PREPARATION FOR INSTALLATION
1. Place the bracket on the wall * where you want to install it. Use a leveler and
observe the bubble to verify that the support is level.
2. Make the marks for the perforations.
*Make sure there are no hidden pipes with electrical, gas or water wiring
Use the base of the support as a template to make the marks of the perforations on the surface where you want to install the equipment.
1b
SUPPORT INSTALLATION (ON CONCRETE)
1. Use a 10 mm drill bit to drill on the marks you made, at a depth of 60 mm
2. Insert the anchors (E) into the holes. Mount the support and fix it with the pins (D) and the
washers (F).
E
2. Loosen the fixing screws, and mount the screen on the support by first placing the upper part of the bars (hooked) and
2b
then the lower part.
3. Tighten the retaining screws again until they reach the top of the support base.
STV-116
Instruction manual
1118A
V0.1
M6x60
M6X11
D (4 pieces)
O (2 pieces)
Separator bushing
Nut
S (4 pieces)
T (2 pieces)
√
Make sure that the bars are perfectly coupled
IMPORTANT
Before using the product, please read the following instructions.
The information shown in this manual serves only as a reference for the product.
Due to updates there may be differences.
Please check our website www.steren.com for the most recent version of this manual.
CAUTIONS
•Choose a solid and smooth wall to securely fix the support.
• Do not over tighten the screws.
• This product is designed for indoor use. Using it outdoors could cause personal injuries and failures.
• Avoid falling equipment, as it could be damaged.
• Do not exceed the maximum load capacity of 35 Kg.
• This device is not intended for use by people (including children), whose physical, sensory or mental
abilities are different or reduced, or who lack experience or knowledge.
• Children should be supervised to ensure they do not use the device as a toy.
TOOLS NEEDED
Clamping bars
Plate of
support
2a
INSTALLING THE SCREEN
1. Use 4 screws (A or B), the 4 spacers (S) and the 4 washers (G or F) to fix the bars on the
back of the screen. If you require wider screws, only use the screws (C) and the bushings
(S), without the washers.
!
Do not install screens larger than 70 "or weighing more than 35 kg
The screws supplied are standard sizes. We recommend you consult the instruction manual of your screen to obtain
information about the screws needed to mount it in a support
3
ADJUSTMENTS
1. Slightly loosen the butterflies of each bar, and tilt the screen
until you reach the desired position.
2. Press the butterflies again to fix the position.
TV
A, B o C
G o F
S
Place on each of the bars, the nut (T) and the screw (O),
that will fix the tilting position.
3. Stretch or retract the arms for a frontal and lateral adjustment,
until obtaining the desired position.
TV
Publicidad
