Care And Maintenance - THOMSON WHP3203D Instrucciones De Uso

6. Installing the transmitter/charging station, Fig. 3
Warning
• Only operate the product from a socket that has been approved for the device. The
socket must be installed close to the product and must be easily accessible.
• Disconnect the product from the power supply using the On/Off switch – if this is not
available, unplug the power cord from the socket.
• If using a multi-socket power strip, make sure that the total power consumption of
all connected devices does not exceed the power strip's maximum throughput rating.
• If you will not be using the product for a prolonged period, disconnect it from mains
power.
• Connect the power supply to the power socket on the rear side of the transmitter.
• Connect the power supply to a mains socket.
• Connect the 2.5 mm jack cable from the transmitter / charging station to the headphone
jack socket (charge) (right earcup) in order to charge the batteries. To start charging,
switch the headphones off using the power button on the right earcup (R).
• The charge LED on the transmitter will now be green.
7. Installing the receiver/headphones, Fig. 2
• Carefully pull off the earpad on the right-hand side.
• Insert the two batteries supplied, making sure you observe correct polarity.
• Reinsert the earpad until it audibly clicks into place.
8. Getting started, Fig. 3
• Connect the audio input to the headphone output jack of an audio device (e.g. ampli er)
using the 3.5 mm jack cable. If required, use a 3.5 mm – 6.3 mm adapter (not included
in delivery).
• Switch on the audio source connected to the transmitter (TV or audio player).
• Switch on the headphones by pressing the Power button (3). The LED (7) of the headphones
lights up green. Make sure that the red LED (2) is lit. This con rms that the rechargeable
batteries are charged.
• Put the headphones on and set the volume to the desired level.
• Before using the headphones for the rst time, make sure that the battery is fully
charged. Charge the battery for at least 24 hours before the rst use.
• Turn the headphones off after use and connect them to the transmitter / charging station
using the 2.5 mm jack cable in order to recharge the batteries.
Note
• If you cannot get an optimum signal frequency, press the Auto-Tune button (5) on
the headphones.
• If you cannot get an adequate frequency, change the frequency channel on the rear
side of the transmitter. Then con rm the corresponding channel on the headphones
by pressing the Auto-Tune button.
• To get the best sound experience with your headphones, you should set the volume
of the sound source (TV, stereo system, etc.) as high as possible and reduce the
volume on the headphones themselves.
The transmitter will automatically switch off if it receives no audio signal for
approximately 2 minutes, or if the signal from the audio source is too weak for
awless reception. As soon as the signal strength is su cient, the transmitter will
automatically switch back on. The headphones do not switch off automatically.
Note
• To prevent damage to the batteries, always switch off the headphones when they
are not in use.
• Before using the product for the rst time, the batteries should be fully charged.
To guarantee an acceptable charge, the batteries should initially be charged for 24
hours. Subsequent charging cycles then last approximately 10 hours.
• The batteries will not be charged if the transmitter is off.
9. Troubleshooting
9.1 No sound
• Check that the power supply plug is fully inserted into the mains socket and the other
end is properly connected to the power supply socket on the transmitter.
• Make sure that the headphones are on.
• The battery in the headphones may have insu cient remaining charge. Charge the
battery.
• Check that your TV, hi- system or audio source is switched on and a channel is correctly
con gured to send an audio signal.
• Increase the volume using the control on the headphones.
• The connected audio/video device may not be in playback mode. Please start the
playback.
• The output volume of the audio source may be too low. Adjust the volume accordingly.
•
• 9.2 Distortion
• Press the Auto-Tune button.
• Set a different frequency channel (1, 2 or 3). Then press the Auto-Tune button again.
• The battery in the headphones may have insu cient remaining charge. Charge the
battery.
• Increase the volume using the control on the headphones.
• The distance between the headphones and the transmitter may be too great. Move the
two devices closer together and turn the headphones in the direction of the transmitter.
• The input level of the audio signal may be too low. Increase the volume of the audio
source.

10. Care and Maintenance

Note
Disconnect the device from the power supply before cleaning it or if it is not going
to be used for a long period of time.
Only clean this product with a slightly damp, lint-free cloth and do not use aggres-
sive cleaning agents.
11. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no warranty for damage
resulting from improper installation/mounting, improper use of the product or from
failure to observe the operating instructions and/or safety notes.
12. Service and Support
Please contact Hama Product Consulting if you have any questions about this
product.
Hotline: +49 9091 502-0 (German/English)
Further support information can be found here: www.hama.com
13. Recycling Information
Note on environmental protection:
After the implementation of the European Directive 2012/19/EU and
2006/66/EU in the national legal system, the following applies: Electric
and electronic devices as well as batteries must not be disposed of with
household waste. Consumers are obliged by law to return electrical and
electronic devices as well as batteries at the end of their service lives to
the public collecting points set up for this purpose or point of sale. Details to this are
de ned by the national law of the respective country. This symbol on the product,
the instruction manual or the package indicates that a product is subject to these
regulations. By recycling, reusing the materials or other forms of utilising old devices/
Batteries, you are making an important contribution to protecting our environment.
14. Declaration of Conformity
Hereby, Hama GmbH & Co KG declares that the radio equipment type
[00131966] is in compliance with Directive 2014/53/EU. The full text of
the EU declaration of conformity is available at the following internet
address:
www.hama.com -> 00131966 -> Downloads
3