Important Information - DURAVIT Stonetto 720145 Instrucciones De Montaje

Important information

Intended use
The mounting instructions come as part of the Duravit
shower trays and must be read carefully prior to
installation.
Target readership and qualifications
The shower trays must only be installed by trained
plumbing engineers.
Explanation of the symbols
Link to the mounting instructions in this section
Inspection (e.g. for scratches)
Indication of the length of time (e.g. 10 minutes)
Inspect to check for leaks and leak-tightness
> Action required
Safety instructions
Product and/or property damage
The breach of local and country-specific regulations and
standards can cause damage to the product
and/or property damage.
> Observe the local installation regulations and any
country-specific standards at all times.
Mounting instructions
Please read pre-installation information sheets prior to
the installation. These are available to download on the
Internet at www.duravit.com.
A2 B2 C2
Using the sealing set
> Use the optional sealing set # 792803 to install
DuraSolid shower trays flush with the floor
depending on the position of the installation and
the site conditions.
> Observe the separate instructions for mounting the
sealing set.
Variant A
A17
Using silicone without acetic acid
> Use alkoxy-based silicone.
Variant B
B3
Installing the shower tray flush with the floor
> Observe the installation heights of the individual
products (a+b) and the height of the adhesive layer
(z) to install the shower tray flush with the floor.
B17
Using the wall profile
> Use the optional wall profile # 790104 for sound
insulation and to accommodate expansions in the
screed depending on the position of the installation
and the site conditions.
B25
Using silicone without acetic acid
> Use alkoxy-based silicone.
Variant C
C3
Installing the shower tray flush with the floor
> Observe the installation heights of the individual
products (a+c) to install the shower tray flush with
the floor.
C5
Installing the shower tray flush with the floor
> Observe the installation heights of the individual
products (a+d) to install the shower tray flush with
the floor.
C15
Using the wall profile
> Use the optional wall profile # 790104 for sound
insulation and to accommodate expansions in the
screed depending on the position of the installation
and the site conditions.
C21
Using silicone without acetic acid
> Use alkoxy-based silicone.
5
DU_M_Stonetto/16.07.5