Adjusting Mounting Rails - Tripp-Lite SmartRack 2400 Serie Manual Del Usuario

Enclosure Configuration
Adding or Removing Side Panels
3 Lift the panel away from the brace that supports it.
To Reinstall Side Panel, Reverse Steps 1-3

Adjusting Mounting Rails

WARNING: Do not attempt to adjust rails without assistance. Do not attempt to adjust rails while equipment is installed in the enclosure. Do not
attempt to use rails without screws installed (4 per rail).
The 4 mounting rails are pre-installed to accommodate equipment with a mounting depth of 30 inches (762 mm). Do not adjust the mounting rails unless your
equipment requires a different mounting depth. The front and rear sets of rails can be adjusted independently in ¼-inch (6 mm) increments for mounting depths
between 4 inches (101.6 mm) and 42 inches (1066.8 mm).
1 Each rail is connected to the enclosure with 4 screws - 1 pair at the upper beam
lower beam .
B
2 Remove the screws fastening each of the rear mounting rails to the enclosure. (If adjustment of the
front rails is required, you can also remove the screws from the front rails.)
3 Slide the mounting rails to the desired depth and reattach them using the screws you removed in
Step 2. The rail attachment points are numbered
depth.
(continued)
A
A to help you align each pair of rails at the same
10
3
and 1 pair at the
A
1
2
3
B
A