Glossary Of Terms; Features; Assembly - Ryobi YG200BN Manual Del Operador

Activate (operating controls)
To move an operating control so that it is in a position that
allows the tool to be actuated or that satisfies one requirement
for the tool to be actuated.
Actuate (tool)
To cause movement of the tool component(s) intended to
drive a fastener.
Air inlet port
In an air tool, the opening to which the compressed air supply
is connected, usually by means of a threaded fitting.
Fastener
A staple, pin, brad, nail, or other fastening device which is
designed and manufactured for use in the tools within the
scope of this standard.
Jam
An obstruction in the feed or drive areas of the tool.
Maximum air pressure
The maximum allowable pressure of the compressed air, as
specified by the manufacturer, for operating a tool.
PRODUCT SPECIFICATIONS
Operating Pressure............................................. 70-120 psi
Fastener Type ...................................... 18 gauge brad nails
Fastener Range ............................................. 5/8 in. to 2 in.
Magazine Capacity ................................................110 nails
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call
All manuals and user guides at all-guides.com

GLOSSARY OF TERMS

FEATURES

ASSEMBLY

1-800-525-2579
6 - English
Operating control
A control that separately, or as part of an actuation system,
can cause the actuation of a tool.
Single sequential actuation
An actuation system in which there is more than one operating
control and the operating controls must be activated in a
specific sequence to actuate the tool. Additional actuation
can occur when a specific operating control, other than a
workpiece contact, is released and re-activated.
Trigger
A tool operating control activated by a tool operator's fingers.
Workpiece
The intended object into which a fastener is to be driven
by a tool.
Workpiece contact
An operating control element or assembly on the tool intended
to be activated by the material to be fastened.
Air Consumption............................ 0.06 ft
Air Inlet .............................................................. 1/4 in. NPT
Weight ..................................................................... 3.4 lbs.
WARNING:
Do not attempt to modify this product or create
attachments or accessories not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
for assistance.
/cycle at 100 psi
3