Rear Panel
1. Network Cable Connector
The Wireless Internet Camera's rear panel features an RJ-45
connector for connections to 10Base-T Ethernet cabling or
100Base-TX Fast Ethernet cabling (which should be Category 5
twisted-pair cable).
The port supports the N-Way protocol and "Auto-MDIX" function,
allowing the Wireless Internet Camera to automatically detect or
negotiate the transmission speed of the network.
2. External Antenna
The external antenna allows you to adjust its position to obtain
the maximum signal.
3. Reset Button
Reset will be initiated when the reset button is pressed once, and
Power LED begins to fl ash.
Factory Reset will be initiated when the reset button is pressed
continuously for three seconds or when Power LED begins to
light up. Release the reset button and the Power LED will begin
to fl ash, indicating the Wireless Internet Camera is changing to
factory reset. When factory reset is completed, the Wireless
Internet Camera will be set to default on channel 11 and SSID is
ENGLISH-6