Bassinet Assembly; Bassinet Operation - UPPAbaby 0210 Manual Del Usuario

BASSINET ASSEMBLY

SETTING UP THE BASSINET
STEP 1: Remove mattress.
STEP 3: Pull bassinet canopy handle upright until an
audible "click" is heard.
6
STEP 2: Pull both steel braces firmly towards the outer
ends of the bassinet into their respective sockets.
Make sure both braces are properly locked in place.
STEP 4: Zip bassinet cover onto bassinet frame.

BASSINET OPERATION

ATTACHING BASSINET TO STROLLER FRAME
To Attach Bassinet to Stroller Frame: Guide the
bassinet hubs over the posts on the stroller frame.
Push until you hear a "click" on both sides.
NOTE: Check that safety indicator is green to ensure
bassinet is properly installed.
CANOPY VENTILATION
STEP 1: Unzip the bottom zipper STEP 2: Lift and line up seam
on the canopy hood. half-way until magnets connect.
COLLAPSING BASSINET
STEP 1: Collapse bassinet canopy by simultaneously
pressing buttons on both sides and pushing back.
To Remove Bassinet from Stroller Frame: Slide plastic
button on carry handle in the direction indicated
and press down to release bassinet. Lift bassinet off
frame using carry handle.
For Additional Ventilation: Undo
Velcro flap found on bottom exterior
of bassinet and adhere to lower
Velcro strip.
STEP 2: Lift mattress out of the way. Disengage by
pulling steel braces from their respective sockets.
7