Turning The Appliance On And Off; Selecting The Operation Function; Cooling - Siemens PA20001M Instrucciones De Uso

Notes
Do not extend the hot air expulsion tube
more than necessary (maximum length;
140 cm).
Do not form sharp bends when positioning
the tube, otherwise the correct expulsion
of hot air may be impeded. This may cause
a reduction in the cooling power and
performance of the appliance.
In order to achieve maximum cooling
efficiency and minimum noise levels, the
expulsion tube should be fitted above the
total height of the appliance, Fig. 16.
Fig. 16

Turning the appliance on and off

Press the "On" / "Off" key
appliance.
Warning!
Make sure that the appliance is plugged
into the mains electricity supply.
Instructions for Use
to start the
36

Selecting the operation function

The following functions can be selected on
your appliance:

cooling

.
dehumidification
air purification
Place the selection box on the operation
function menu using the "up" and "down"
keys (see "Navigation": "up" and "down" keys).
Use the "+" and "–" keys to move within the
selection box and select the desired function
(see "Navigation": "+" and "–" keys).
Cooling
In this function, the appliance reduces ambient
temperature until the desired temperature is
reached. The appliance dehumidifies and
purifies the air in the room at the same time in
order to create a pleasant atmosphere.
Plug the appliance into the mains electricity
supply.
Lead the hot air expulsion tube outside,
(see "Preparing the appliance before use").
Check that the plug is fitted onto the water
drainage pipe to prevent water from leaking
onto the support surface.
Lift the air director on the top of the
appliance, Fig. 17.
Turn the appliance on by pressing the "On"
key .
Select the cooling function
"Selecting the operation function").
Select the desired temperature, (see
"Selecting the temperature").
Select the operation speed, (see "Selecting
the speed").
.
.
Fig. 17
, (see