Installation - Bradley S19-670 Guia De Instalacion

Installation

Installation
Step 1: Install hose spray and hose
1. Connect the hose spray (item 7.1) and hose
(item 8) to the tank outlet with pipe sealant
(supplied by installer) (see page 5. Do not
attach the body wash sprayhead (item 7.3) at
this time.
IMPORTANT: When attaching the hose
and pressure gauge to the tank outlet,
hold the adapters (items 2 and 3) with a
wrench to prevent stripping. Failure to
do so may damage the seal and cause
leakage. Max. torque 150 in-lbs.
2. Connect the pressure gauge to the adapter on
the pressure side of the tank with pipe sealant
(supplied by installer) (see page 5).
Step 2: Fill tank and pressurize
1.
If the tank is pressurized, relieve the tank
pressure by pulling up on the relief tank tab in
the center of the cover until the pressure gauge
reads "0."
IMPORTANT: DO NOT open the cover
until the pressure gauge reads "0."
2. Open the tank by pulling up on the wire handle
located on top of the Quicklock cover. Push
down, rotate and remove. Fill the container with
3-1/2 gallons of potable water. Replace the
cover.
3. Pressurize the tank to 90 PSI by applying air
pressure to the tank valve located beneath the
pressure gauge.
NOTE: Relief valve is designed to automatically
vent at 100-130 PSI to prevent the tank from
overpressurizing.
Step 3: Flush tank; attach eye/face wash head
1.
Discharge the water through the hose spray to
flush the system.
2. Attach the body wash sprayhead.
3. Refill the tank and pressurize as explained in
Step 2 outlined above.
NOTE: Let unit stand for one hour. If there is a
noticeable pressure drop, repressurize and let
stand for one hour. If problems persist, consult the
Troubleshooting guide found on page 4.
NOTE: This unit will provide at least 7 minutes
of cleansing action. Take the injured person
immediately to a normal emergency station for
additional cleansing and treatment.
Bradley Corporation • 215-321 Rev. T; ECM 08-539
25"
(635mm)
8½"
(216mm)
6/9/09
S19-670
3