Publicidad
Idiomas disponibles
Idiomas disponibles
17. Remove the motor shaft protector.
18. Remove the 4 screws indicated in the photo.
19. Position the grid so that the holes for the screws coincide.
20. Screw in with the screws that were removed in the previous step (18).
21. Loosen the propeller screw.
22.
Align in the same position the screw of the propeller with the chamfer of the motor shaft.
23. Insert the propeller in the aligned shaft and tighten the screw.
24. We already have the propeller mounted.
25. Open the 3 tabs of the rear grid.
26. Place the front grid and close the tabs.
¡¡...
DONE
...!!
Publicidad
