Publicidad
Idiomas disponibles
Idiomas disponibles
3.12 Use of cleaning pin
The Cleaning Pin can be used if the gun has
jammed.
4. After use instructions
The machine should be stored in a frost-free
room!
Pump, hose and accessories should always
be emptied of water prior to storing as
follows:
Stop the machine (press the start/stop
switch, "O" and detach water hose, high
pressure hose and nozzle
Restart the machine and activate the trigger
of the trigger gun. Let the machine run until
no more water runs through the trigger gun
Stop the machine, unplug and wind up hose
and cable.
Place trigger gun, lance, nozzles and other
accessories in the holders of the machine.
The hook can be used for storage of the
hose and cord. All accessories can be stored
in the washer after use.
WARNING: Never start up a frozen
machine. Frost damages are not covered by
the guarantee.
5. Environmental protection
Old appliances contain valuable materials
that can be recycled. Please arrange for the
proper recycling of old appliances. Please
dispose of your old appliances using
appropriate collection systems.
6. Maintenance, cleaning and repair
WARNING! Always disconnect the
electrical plug from the socket prior to
maintenance or cleaning.
To ensure a long and problem free working
life, please follow these guidelines:
Wash out water hose, high pressure hose,
spray lance and accessories before
mounting.
Clean the connectors of dust and sand.
Rinse the detergent spraying attachment
after use.
Clean the nozzles.
Any repair should always be made in an
authorized workshop with original spare
parts.
6.1 Cleaning of inlet filter
Clean the water inlet filter regularly once a
month or more frequently according to use.
Carefully loosen the filter with a
screwdriver and clean the filter. Check that
it is intact before re-mounting it.
The inlet filter must always be fitted inside
the water inlet pipe to filter out sand,
limestone and other impurities, as they will
damage the pump valves.
CAUTION: Failure to fit the filter will
invalidate the warranty
6.2 Cleaning of air vents
The machine should be kept clean so as to
let cooling air pass freely through the
machine vents.
6.3 Greasing of couplings
To ensure an easy connection and that O-
rings do not dry up; the couplings should be
greased regularly.
10
Publicidad
