Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT: Point the nozzle at the
ground.
Check that the machine is in upright
position. NOTE: Do not place the machine
in high grass!
Release the trigger lock.
Activate the trigger of the trigger gun (1)
and let the water run until all air has
escaped from the water hose.
Press the Start/stop switch (7).
Activate the trigger of the trigger gun (1).
Always adjust the distance and thus the
pressure of the nozzle to the surface, which
is to be cleaned.
Do not cover the machine during operation
or use it in a room without adequate
ventilation!
NOTE: If the machine is left or not used
for 5 minutes, it must be switched off on the
start/stop switch (7) "O":
To stop: Press the start/stop switch (7) "O".
Disconnect the electrical plug (12) from the
socket.
Shut off the water supply and activate the
trigger of the trigger gun (1) to relieve the
machine of pressure.
Lock the trigger gun (1)
When releasing the trigger of the trigger
gun (1), the machine automatically stops.
The machine will start again when you re-
activate the trigger gun (1)
3.6 Adjustable Nozzle
The pressure of the normal nozzle can be
adjusted by tuning it. WARNING: Do not
do this while the machine is being operated
to avoid the jet hitting the hand and causing
injury.
3.7 Install indicator diagram
1.Gun hook assembly:
2.Cable hook assembly
8
Publicidad
