Cequent Performance Products 24792 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 24792F
Wrenches: 3/4, 11/16
Drill Bits: None
Hitch Requires ½" pin and clip.
Access
Hole
1"
Area To Be
Enlarged
Figure 2
j
Qty. (2) 7/16-14 X 1.50 Carriage Bolt GR5
k
Qty. (2) 1/4 X 1.00 X 3.00 Spacer
l
Qty. (2) 7/16 Conical Toothed Washer
m
Qty. (2) 7/16 Hex Nut
n
Qty. (1) 1/2-13 X 2.50 Carriage Bolt GR5
1. Lower exhaust by removing rubber isolators from muffler hangers.
2. Enlarge existing hole in both frame rails to allow access for 1.00 X 3.00 spacers to be inserted as shown in Figure 2.
3. Insert carriage bolts and block into frame rails and raise hitch into position.
4. Loosely install conical toothed washers and hex nuts.
5. Position hitch and loosely install tow hook attachment fasteners.
6. Tighten all fasteners to the required torque specification.
7. Raise exhaust back into position and re-install rubber isolators.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2006, 2007, 2009, 2015 Cequent Performance Products – Printed in México
Installation Instructions
Honda CR-V
Fascia
(Sold separately)
Drawbar Kit:
3592
Drawbar must be used in the
Rise position only.
Frame Rail
Access Hole To
Be Enlarged
Both Sides
Tighten all 7/16-14 GR5 fasteners with torque wrench to 50 Lb.-Ft. (68 N*M)
Tighten all 1/2-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
Wiring Access Location: SUV3
Tow Hook
o
Qty. (1) 1/4 X 1.00 X 2.00 Spacer
p
Qty. (2) 1/4 X 1.00 X 2.00 Spacer (Round Hole)
q
Qty. (1) 1/2 Conical Toothed Washer
r
Qty. (1) 1/2 Hex Nut
s
Pull Wire 7/16"
Qty. (2)
Sheet 1 of 3
Part Numbers:
24792
77147
60869
s
24792N 10-09-15 Rev. D