Controls - MTD 240 Serie Manual Del Operador

Controls and Features
Tine Clutch
Back of Tiller
Depth
Stake
Tine Clutch Control
The clutch control lever is located on the upper handle.
Squeezing the lever against the handle engages the tine drive.
Release the lever to stop the tines from turning.
Handle Knobs
The handle height may be adjusted. Loosen the knobs and
remove the carriage bolts to change the position. Reinstall and
tighten the hardware when complete.
Recoil Starter
The recoil starter is located on the engine and is used to
manually start the engine.
Depth Stake
The depth stake acts as a brake for the tiller and controls the
depth and speed at which the machine will operate.
10
Control
Clutch Cable
Handle Knobs
Depth Stake
Rear
Wheel
Rear Wheel
Recoil Starter
Figure 4-1
Rear Wheel with Depth Stake
The rear wheel can be raised and lowered for transport and
storage. Refer to the Maintenance & Adjustments Section for
instructions on depth stake adjustment and the Assembly & Set-
Up Section for instructions on wheel adjustment.
Engine Controls
Refer to engine manual for additional information and functions
of the engine controls.
Throttle Control (If Equipped)
The throttle control lever is located on the engine. It controls the
engine's speed and stops the engine.
Primer
The primer, located on the engine, is used to pump gas into the
carburetor and aid in starting the engine. Use it to start a cold
engine, but do not use it to restart a warm engine after a short
shutdown.
4
Tines