VMB TL - A220 Manual De Instrucciones página 14

Quick Operation Guide
Place the bars in their transport compartment.
Remove the outriggers, releasing the locks and
place in their transport position (S). Turn and
tighten the fixing screws (J). The lift can be
transported horizontally by adding the RH-2 kit.
5. MAINTENANCE.
5.1 - Periodically check the condition of the
cable. If a cable is torn or broken it should be
replaced immediately. Do not use the lift if the
cable is not perfect. Only use torsion resistant
steel cable DIN 3060.
5.2 - The lift is supplied completely greased
from the factory. Never the less, we
recommend you periodically grease (depending
on amount used) the teeth of the winch (CD),
end point of the handle (RM), bar (EB) (Fig. 8)
and the profile nylon drums.
EB
CD
ATTENTION: Do not grease or lubricate the
break mechanism.
The brake discs have been greased with a
special heat and pressure resistant grease. Do
not use other products.
PRO LIFTS S.L.
5.3 - All lifts should undergo an annual
technical inspection carried out by an
authorized VMB dealer to check the
certifications and general condition of all the
lift's elements and security systems involved
in the lift's use.
5.4 - Only use original spare parts to guarantee
a continued security level.
The user loses all rights to warranty if any spare
parts other than originals are used or carries
out any modification or alteration to the towerlift.
5.5 - To request a spare part please indicate
the corresponding code which can be found in
this manual.
6. GUARANTEE.
If the during the guarantee period because of
poor workmanship or faulty materials PRO
LIFTS will repair or replace it. The guarantee
period is at 2 years.This guarantee does not
cover damage caused by improper use, wear
and tear unauthorised repairs. The guarantee
does not cover consumables or defects that
EB
have only a negligible effect on the value or
operation of the elevator tower.
7. CERTIFICATIONS
-
RM
Fig. 8
BGV C1 (GUV-VC1) / BGG 912 (GUV-G912)
V.11.03 - Depósito legal y Copyright 2011. Todos los derechos reservados.
ENGLISH
EC Machinery Directive
89/392/ECC and 98/37/ECC