Charging The Battery - Ewbank CFP500 Manual De Instrucciones

Please ensure the battery pack is connected to the unit before charging.
The battery must be fully charged before the Cordless Floor Polisher is used for the very first
time. The first charge may take 7-8 hours, with subsequent regular charging taking approx.
4 hours. The charging indicator located on the charger plug glows red whilst charging is in
progress and will turn green once the battery is fully charged.
CAUTION - DO NOT USE THIS PRODUCT ON CARPET
• Before first use remove the plastic isolation tube from the charger socket and discard.
• When the handle is in a vertical upright position the battery remains isolated and the cleaning
head will not rotate. Tilt the handle away from a vertical position to use the polisher.
• Attach the polishing pad onto the grips located on the bottom of the rotating head, ensuring the
pad is central to the head.
• Push the ON/OFF button to begin rotating head motion.
• To stop the head from rotating press the on/off switch or put the handle into a vertical
upright position.
• When cleaning keep the rotating head moving across the floor surface at a gentle speed.
• Only use dedicated floor cleaning products. The recommended cleaner is Ewbank Floor Polish
available from Ewbank stockists.
• Always follow the manufacturer's instructions for floor cleaning products.
• Use the textured front side of the pad to clean your floor.
• Use the reverse white side of the pad to buff and polish to a shine.
• When cleaning sensitive surfaces apply the polisher in the first instance to a small, less
obvious area, i.e. the corner of a room.
• Ensure that no grit or sharp particles are stuck to the pad as these may cause damage to
the floor surface.
Cleaning and caring for your Cordless Floor Polisher
• Ensure charger unit is unplugged before
cleaning the floor polisher unit.
• Clean the casing with a damp cloth and mild
detergent.
• The cleaning pads are machine washable.
• If any dirt enters into the gap between the
rotating head and the base of the unit,
ensure the unit is switched off, clip off the
rotating head first and remove the dirt.

Charging the battery

Using your Cordless Floor Polisher
5