Cequent Performance Products 24819 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 24819F
Wrenches: 12mm, 13mm
Drill Bits: None
Note: Fasteners typical
both sides
j
Qty. (4) M8 x 1.25 x 30mm, CL 10.9
1. Remove the two plastic fascia rivets from the fascia tabs (Do not discard).
2. Remove the vehicle inboard bolt and the lower bolt located on each side of the end panel.
3. Raise hitch into position.
4. Install M8 bolts and conical toothed washers.
5. Re-install the plastic fascia rivets removed in installation Step 1.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2008, 2010, 2015 Cequent Performance Products – Printed in Mexico
Installation Instructions
Fascia
Toyota Yaris
Drawbar Kit:
3593
(Sold separately)
Drawbar must be used in the
RISE position only.
End panel
k j
Tighten all M8 CL10.9 fasteners with torque wrench to 27 Lb.-Ft (37 N-M).
Do Not Exceed Lower of Towing Vehicle
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
Wiring Access Location: PC3, PC4
End panel
k
Qty. (4) Conical Toothed Washer
Sheet 1 of 3 24819N
Part Numbers:
24819
60209
77191
24821
Manufacturer's Rating or
Note: Rotate the hitch for
ease of installation.
10-09-15
U-Haul
Rev. C