Cequent Performance Products 75217 Instrucciones De Instalación página 4

1. Lower the exhaust by removing (4) rubber hangers, and support the
exhaust with a ratchet strap.
3. Raise the hitch above exhaust, feed fishwires through the attachment
points on hitch brackets. (Pull back the rear fascia if needed to gain access
between the fascia and exhaust hanger.)
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
2. Scrape the undercoating at the bottom of frame on both sides. Fishwire 1/2"
carriage bolt and spacer through the access hole and out the forward mounting
hole. Reverse pull fishwire 1/2" carriage bolt and spacer through the access
hole. See Figure 2 for fishwire methods.
4. Remove the fishwires and secure the hitch with conical washers and hex
nuts.
Sheet 4 of 15 75217NP
Access hole
4-24-15 Rev. A