GLIDEAWAY Comfort Base Lifestyle Serie Manual De Instrucciones página 11

Assembly - Head Board Bracket
3
3
Attach the head board
Attach the head board
attachment plate (Part C) to
attachment plate (Part C)
the horizontal shaft (Part B)
to the horizontal shaft
using the two flat head self
(Part B) using the two at
locking screws (Part E), two
head self locking screws
washers (Part G) and two nuts
(Part E), two washers (Part
(Part F) provided with the kit.
G) and two nuts (Part F)
provided with the kit.
4
Insert, from the
4
Insert, from the outside of the
outside of the bed,
bed, the horizontal shaft (Part
the horizontal shaft
B) into the horizontal fitting of
(Part B) into the
the bed attachment (Part A).
horizontal tting of
the bed attachment
(Part A).
5
Adjust the position of
the head board
5
Adjust the position of the head
attachment plates (Part
board attachment plates (Part
C) to the right or the left
C) to the right or the left of the
of the bed as desired by
bed as desired by moving the
moving the horizontal
horizontal shaft (Part B) left
shaft (Part B) left and
and right in the horizontal fitting
right in the horizontal
of the bed attachment (Part
tting of the bed
A). Once positioned correctly
attachment (Part A).
tighten screws (Part D) to hold
Once positioned
in place.
To adjust the position of the head board attachment plates (Part C) vertically, loosen
correctly tighten screws
nuts and screws from step 3. Tighten when the appropriate height for your head
(Part D) to hold in place.
board is met.
To adjust the position of the head board attachment plates (Part C)
Install the head board using the line of 3 oval holes on the outside of the head board
vertically, loosen nuts and screws from step 3. Tighten when the
attachment plate.
appropriate height for your head board is met.
WARNING: The end of the horizontal shaft (Part B) must always extend beyond the
Install the head board using the line of 3 oval holes on the outside
end of the horizontal fitting of the bed attachment! (Part A) (See Fig. 5 Arrow)
of the head board attachment plate.
WARNING: The end of the horizontal shaft (Part B) must always
extend beyond the end of the horizontal tting of the bed
attachment! (Part A) (See Fig. 5 Arrow)
Fig. 3
PART B
PART F
Fig. 4
Fig. 5
10
PART G
PART A
PART C
PART A
PART D
PART C
PART E
PART B
PART B