Replacing The Batteries - MAXSA Innovations 40225-L Instrucciones De Montaje Y Funcionamiento

MOTION SENSOR ADJUSTMENT (SENS)
The motion sensor on this Solar Security Light is temperature-sensitive. The cooler the
temperature, the more sensitive the motion sensor will become. Use the SENS dial to
adjust the sensitivity of the motion sensor to compensate for environmental temperature
changes. The motion sensor is most sensitive when the SENS dial is turned fully clockwise
(+).
To decrease sensitivity, move the dial toward the ( – ) symbol.
To increase sensitivity, move the dial toward the ( + ) symbol.
To test the motion sensitivity, aim the sensor head toward the desired area. Set the TIME
dial to minimum ( – ) position and the LUX dial to the bright setting ().
Walk slowly around the area of detection, changing your walking pace until the light comes
on. If light does not come on, you may need to adjust the angle of the sensor unit. Make
adjustments as needed until the desired level of sensitivity is reached. Re-adjust the TIME
and SENS dials when complete.
LIGHT LEVEL ADJUSTMENT (LUX)
The LUX dial controls the natural light level that triggers the Solar Security Light and
prevents the light from operating during daylight hours.
Your Solar Security Light comes preset for activation at dusk.
To adjust for activation in a brighter setting, move the dial toward bright ()
To adjust for activation in a darker setting, move the dial toward dark ( ).

REPLACING THE BATTERIES

When the charging ability of the batteries decreases, you can replace them with two (2)
new 3.7V/3.6 Ah Lithium-Ion batteries. Follow the steps below when replacing batteries.
First remove the main unit from its mounted surface and unplug the solar panel.
1.
2. Move the power switch on the main body to the OFF position.
Remove the four (4) screws on the back of the main unit that hold the halves together.
3.
Once the unit is open, carefully remove the bracket holding the battery pack in place
4.
by unscrewing the two (2) screws as indicated in the diagram above.
Carefully unplug the battery pack from the unit. Be sure to pull by the base of the plug.
5.
Do not pull the plug by the wires as this may damage the unit.
Carefully remove the battery pack and replace with a new 3.7V/ 3.6 Ah Lithium Ion
6.
Battery Pack
5