Replacing The Rechargeable Batteries; Maintenance Tips - MAXSA Innovations 44215 Instrucciones De Ensamble

Motion-Activated Dual-Head Solar Security Light
LIGHT LEVEL ADJUSTMENT (LUX)
The LUX dial controls the natural light level that initiates operation and prevents the security light
from operating during daylight hours.
To adjust the light level control, turn the LUX control fully clockwise toward the ( ). (. Wait until
the natural light falls to the required level that you wish to activate your solar security light.
Rotate the LUX control slowly counter-clockwise until the Solar Security Light illuminates.

REPLACING THE RECHARGEABLE BATTERIES:

When the charging ability of the batteries decreases, you can replace the batteries with (3) three
new AA Ni-MH 1.2 V rechargeable batteries. Follow the steps below when replacing the battery.
1. First remove the main unit from its mounted surface
2. Move the power switch on the main body to the OFF position.
3. Remove the four (4) screws on the battery compartment cover on the back of the main
unit.
4. Carefully slide out the battery tray and turn the tray over.
5. Carefully remove the old batteries from the compartment by hand and replace with three
(3) new AA Ni-MH 1.2V rechargeable batteries.
6. Turn the battery tray back over and reinsert the tray into the main unit
7. Replace the battery compartment cover and reinstall the four screws.

MAINTENANCE TIPS:

Importantly, ensure that the solar cell charge panel is kept free of dirt and debris at all times. A
dirty solar panel will not allow the batteries to fully charge and this will shorten the life of the
batteries and may cause the light to malfunction.
STORAGE
For optimal performance, we recommend that you do not store your Solar Security Light for
prolonged periods of time. If you wish to store your light indoors for more than two or three days,
turn to power switch to the OFF position to prevent damaging the battery.
4