How To Assemble And Use - Hamilton Beach 50111 Guía De Uso

840140200 ENv01.qxd

How to Assemble and Use

IMPORTANT: Your blender jar and
cutting blades are subject to wear
during normal use. Always inspect jar
for nicks, chips, or cracks. Always
inspect cutting blades for broken,
cracked, or loose blades. If jar or cut-
ting blades are damaged, do not use.
Call our toll-free customer service
number to obtain replacement parts.
1. Make sure blender is unplugged.
Place blender base on clean, dry
surface to keep foreign particles
from being pulled up into motor
during operation.
2. Place cutting blade assembly in
the collar. gasket over blades. The
gasket must lie flat. Set jar on top
of gasket and screw onto collar.
3. Make sure the collar is firmly
screwed onto the jar. If not, it may
loosen later when motor is turned
on.
Fill blender jar with 1 cup (250 ml) of
ice cubes. Place lid on blender jar
then Pulse. Allow blades to come to a
complete stop between pulses.
• Processing hot foods or liquids in
the blender may cause hot liquid to
spurt out when the lid is removed.
Always remove the filler cap of the
cover before blending hot foods or
liquids. When blending hot liquids,
remove center piece of two-piece
lid. Do not fill blender jar beyond
the 3-cup (750 ml) level. Always
begin processing at the lowest
speed setting. Keep hands and
other exposed skin away from the
cover opening to reduce the risk of
possible burns.
• To add foods when blender is
operating, remove filler cap from lid
and add ingredients through the
opening.
7/13/05 3:25 PM Page 7
Crushing Ice
Hints for Best Use
4. Set jar into place on blender
base, making sure it is securely
seated.
5. Plug cord into outlet.
6. Put ingredients in jar; place lid
on jar. Always hold handle when
blending.
7. Process food or beverages.
See the "Blending Techniques"
section for speeds and
processing tips.
8. ALWAYS turn blender off and
wait until blades have stopped
rotating before removing jar.
9. To remove jar after blending is
complete, lift the jar straight up.
10. NEVER replace jar onto unit
while motor is running.
Continue until ice is crushed to
desired consistency.
• If blending action stops during
blending or ingredients stick to
sides of the jar, turn blender Off /
O. Remove lid and use a rubber
spatula to push mixture toward
blades.
• Do not try to mash potatoes, mix
stiff dough, whip egg whites, grind
raw meat, or extract juices from
fruits and vegetables. The blender
is not made to perform these
tasks.
• Do not store food or liquids in the
blender jar.
• Moisten lip of lid to facilitate
placing lid on jar.
7