How To Assemble; How To Operate - Hamilton Beach 54614 Manual Del Usuario

840154500 ENv03.qxd

How to Assemble

IMPORTANT: Your blender jar and
cutting assembly are subject to wear
during normal use. Always inspect jar
for nicks, chips, or cracks. Always
inspect cutting assembly for broken,
cracked, or loose blades. If jar or cut-
ting assembly is damaged, do not use.
Call our toll-free customer service num-
ber to obtain replacement parts.
1. Make sure blender is unplugged.
Place blender base on clean, dry
surface.
2. Fit gasket over blades as shown in
illustration on page 4. The gasket
must lie flat. Set jar on top of gasket
and screw on cutting assembly.
Make sure the cutting assembly is
firmly screwed onto the jar.

How to Operate

1. Plug cord into outlet.
2. Put ingredients in jar. Place lid with
filler cap on jar.
3. Process food or beverages. See the
"Blending Specific Foods" section
for speeds and processing tips.
NOTE: When blending thin liquids,
do not fill above the 32-ounce/
4 cup/1200 ml mark on blender jar.
4. ALWAYS turn blender off and wait
until blades have stopped rotating
before removing jar.
5. To remove jar after blending is com-
plete, lift the jar straight up. If it is not
easily removed, rock gently and lift.
Do not twist.
NOTE: NEVER replace jar onto unit
while motor is running.
To Use the Spout:
To dispense thick liquids (such as
milkshakes, smoothies, frozen drinks,
etc.), turn the control knob to DISPENSE
and pull spout assembly lever up.
Turn OFF after dispensing.
8/30/06 3:11 PM Page 5
3. Set jar into place on blender base,
making sure it is securely seated.
If not, gently rock the jar until seated.
OPTIONAL: When spout is not
Clean" section). Insert spout adaptor
cap on jar. Turn spout adaptor cap
clockwise to tighten.
4. When spout adaptor cap is not in
use, snap onto bottom of blender
base for storage.
NOTE: Blender MUST be ON to
dispense thick liquids and frozen drinks.
When dispensing thin liquids, it may not
be necessary to turn the blender ON to
dispense the liquid.
wCAUTION
Burn Hazard
Hot liquids may push lid off jar during
blending. To prevent possible burns:
• Remove filler cap.
• Do not fill jar beyond the 3 cup
(750 ml) level.
• With the protection of an oven mitt
or thick towel, place one hand on
top of lid.
• Keep exposed skin away from lid.
• Start blending at the lowest speed.
needed,
replace spout
with spout
adaptor cap.
Remove
spout by
rotating coun-
terclockwise
(see "How to
5