Code Search - GE 24944 Manual De Instrucciones

Control remoto universal
Ocultar thumbs Ver también para 24944:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Code Search

If your device does not respond after you have tried
all the codes for your brand, or if your brand is not
listed, try searching for your code by following these
steps.
1. Manually turn on the device (TV, DVR, etc.) to be
controlled.
2. Press and hold the SETUP button until
the red indicator stays on, then release
the SETUP button.
3. Press and quickly release the desired
device button (TV, DVR, etc.). The red
indicator blinks off once.
4. Press the
(up to 300 times) until the device
to be controlled turns off. The red
indicator blinks off with each button
press.
5. Press and release ENTER to install the
code.
Most users will store VCR codes under the VCR button,
Cable codes under CABLE, etc. If (for example) you
want to store a VCR code under CABLE, first follow
the procedure for Direct Code Entry (previous page)
and press CABLE in step 2 of Direct Code Entry, then
enter ANY VCR code in step 3 of Direct Code Entry.
Then follow the steps above for Code Search.
Note: Code Search starts from the currently stored
four digit number under that mode. Sometimes the
first code that "works" with your device may only
allow limited functionality (e.g. the MENU button
might not work). There may be a code that performs
more functions. Continue the code search process
until the best code is found.
ON•OFF
button repeatedly
7

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido