Auto Code Search - GE 33712 Manual De Instrucciones

Programming Your Remote

Auto Code Search

The Auto Code Search is a process where you can
search through all the codes stored in the remote to find
a code for your device. It is recommended that you read
through all the steps below to familiarize yourself with
the Auto Code Search before starting the process.
1. Manually turn on the device you wish
2. Press and hold down the SETUP button on
3. Press and release the device button on the
tv
4. With the remote pointed at the device,
5. Manually turn the device back on.
6. With the remote pointed at the device,
to control.
Note: The Auto Code Search process cannot be used
for devices without power on/off capability. Use the
Direct Code Entry method in these cases.
the remote until the red light on the remote
control turns on. Release the SETUP button.
The red light will remain on.
Note: The red light will either be a small light at the
top of the remote or the power on/off button.
remote for the type of device you wish to
(for example TV, strm, b-ray, cbl,
control,
dvd, aud).
The red light will blink once and
remain on.
press and release the POWER button
on the remote. The remote will send 10
different codes to the device. The red light
will blink once for each code and remain
on after sending the 10 codes.
Did the device turn off?
• If YES, go to Step 5.
• If NO, repeat Step 4 to test the next
10 codes.
press and release the VOL + button. The
remote will re-send the first code of the 10
codes from Step 4. The red light will blink
once and remain on.
8